Acessories
Remote Control Control Panel
Note:
1.Before installing the air conditioner, please power it on to a regular 220V power socket and run it for 30 minutes to observe the cooling and operating status of the air conditioner host. After confirming that it is in good condition, move it to the car roof for installation. (It is recommended to have a professional install it)
2. Elevator air conditioning is a high-power product and must not be used in conjunction with the original elevator roof power supply. A dedicated cable must be configured, and an independent power supply is recommended with a single cable of no less than 2 square meters (the length of the cable should be higher than the height of the floor, with 20 meters reserved for the machine room). This is subject to the needs of ground construction.
3. Users should pay special attention that the voltage required for elevator air conditioning is 220V. If used incorrectly, it may burn out the air conditioning circuit board and cause the air conditioning to malfunction. Please keep the outer packing carton and foam for at least 15 days.
4. A protective switch should be installed at the front end of the dedicated cable to avoid endangering the safety of the elevator or other equipment in case of air conditioning failure. After the dedicated cable is arranged, fix the air conditioning unit and turn on the power for a second test. After normal operation, proceed to the next step of fixing.
